Door - GE CDT865SxJ0 Series Technical Service Manual

Door

The Door has DC voltage only and contains a UI
(User Interface) Board with all tactile switches on
the board. Some models have a 7-segment display,
others have LED indicator lights. The door also
houses the detergent module, bottom door seal
and a passive venting system (see the Dry System
section in this service guide).
Door Removal
1. Remove power to the dishwasher, then close
and latch the door.
2. Remove the toe kick and insulation (if applicable).
3. Disconnect the door wire harness at the bottom
of the main control cover.
4. Release the wire clip holding the harness to the
tub. Push up on the wire harness to release the
harness.
WARNING: GE Factory Service Technicians are
REQUIRED to follow Lockout / Tagout (LOTO) 6
Step Process prior to beginning repair.
5. Locate the door balance cable and insert an
Allen wrench or tool formed into a hook (as
shown below).
6. Lift the cable up and slide forward.
7. Slide the cable down and away from the
dishwasher. Do not release tension from the
cable.
– 29 –
(Continued next page)