Omron E5xK-T series Manual page 17

E5jK-T
E5CK
Draw-out
Draw out the internal mechanism from the housing.
1. Press in both of the hooks on the left and right sides of the
front panel to unlock the internal mechanism from the
housing.
2. Draw out the internal mechanism towards you holding both
sides of the front panel.
Setting Up the Output Unit
Procedure
1. Two rectangular holes for slotting are provided on the power
board (on right side of Controller). Fit the two protrusions on
the Output Unit into these two holes.
2. With the Output Unit fitted into the power board, fit the Output
Unit into the connector on the control board (on left side of
Controller).
Setting Up the Option Unit
Procedure
1. Place the Controller with its bottom facing up, and fit the board
horizontally into the connector on the power board (on right
side of Controller).
2. With the power board connected, fit the board vertically into
the connector on the control board (on left side of Controller).
Mounting
1. Insert the E5EK-T Controller into the mounting hole in the
panel.
2. Push the adapter along the Controller body from the terminals
up to the panel, and fasten temporarily.
3. Tighten the two fixing screws on the adapter. When tightening
screws, tighten the two screws alternately keeping the torque
to approximately 0.29 to 0.39 N m, or 3 to 4 kgf cm.
Setting the Input Type Jumper
Set the jumper to one of temperature input, voltage input or current
input matched to the type of sensor connected to the input terminal.
I : Current input
TC/PT : Temperature input
The input type jumper is factory-set to "TC/PT (temperature input)."
When you disconnect or insert the input type jumper, do not hold it
directly by its pins.
When you have finished setting the input type jumper, insert the
internal mechanism back into the housing.
To do this, push in the internal mechanism until you hear the hooks
on the front panel snap into place.
E5jK-T
Adapter
Panel
Waterproof packing
V : Voltage input
17