Theben TR top2 Manual page 31

Step 2: PULSE DURATION
Enter the pulse duration using the ◄ und ► push buttons. To do so, select the hours for
the switch-on duration (0 hours) followed by confirmation using the OK push button.
Proceed to select the minutes for the switch-on duration (10 minutes) with the ◄ and ►
push buttons and then confirm with the OK push button.
After this, enter the seconds for the pulse duration with the ◄ und ► push buttons (here
00 seconds).
Step 3: PAUSE
Enter the pause duration using the ◄ und ► push buttons. To do so, select the hours for
the pause (0 hours) followed by confirmation using the OK push button.
Proceed to select the minutes for the pause with the ◄ and ► push buttons and then
confirm with the OK push button.
In the example the pause lasts for 50 minutes since the pulse duration is 10 minutes and the pulse is to
be repeated every hour on the hour.
After this, enter the seconds for the pause using the ◄ and ► push buttons (here 00
seconds).
Step 4: STOP CYCLE
Note:
In the cycle program it is possible to select between an endless cycle (ENDLESS) and cycle with end
(WITH END). In the case of an endless cycle, as with the flashing relay, the change between the pulse
and pause is performed constantly if it has been started once.
Press ► push button since in the example the cycle has an end.
Confirm by pressing OK.
For the example select WITH END, since the cycle is to end at 5.00 pm.
Confirm STOP CYCLE with the OK push button in order to carry out the input for the end
time of the cycle program.
Page | 31