Theben TR top2 Manual page 28

Press ► (scroll to the right) instead of the OK push button since the pulse should not be
performed on a Saturday.
Press ► (scroll to the right) since the pulse should not be performed out on a Sunday
either.
Press OK push button since the selection of the weekdays has been completed (the
pulse should be performed on the weekdays Monday – Friday, however not on Saturday
and Sunday)
After saving, NEW appears on the display since other PULSES can now be programmed.
With the ► push button it is possible to scroll to the END or with the MENU (ESC) push
button the menu can be exited.
Press the OK push button since the pulse which indicates the end of the pause from Monday to Friday
at 9:30 am with a 5-second long ring it still to be programmed.
Press OK button.
Press the OK push button etc. (same procedure as for the programming of the
pulse above).
Note:
With the PULSE program function it is also possible to extend or shorten "normal" switching times in
order to set second-specific switching times which do not begin or end at the start of the minute.
Example: The connected load should be switched ON at 6:00:05 am - and switched OFF at 12:00:20
pm.
 Procedure:
Proceed to programme the switching times ON at 6:00 am and OFF at 12:00 noon.
Then programme an OFF pulse at 6:00:00 am with a pulse duration of 5 seconds.
And finally programme an ON pulse at 12:00:00 noon with a pulse duration of 20 seconds.
Page | 28