Segment Graph Bar Display; Auto Mode And Manual / Permanent Switching - Theben TR top2 Manual

6.2. Segment graph bar display


Each bar graph display shows the programming for a specific time segment:
o
Graph bar display 1:
o
Graph bar display 2:
o
....
o
Graph bar display 47: From 23:00:00 hours to 23:29:59 hours
o
Graph bar display 48: From 23:30:00 hours to 23:59:59 hours

For switching time and pulse the following is applicable:
o
Graph bar ON means that the channel is on for at least 1 second within the time period.
o
Graph bar OFF means that the channel is off for the entire period.

The following is applicable for cycle:
o
Graph bar ON means that a cycle was programmed within the time period.
o
This means that with cycle the actual channel status is not shown however only that a
cycle is active for the period.

The following priorities are also valid for the graph bar display: Cycle has the highest priority,
followed by pulse and then the switching times (switching times have the lowest priority).

6.3. Auto mode and manual / permanent switching


By pressing push buttons ◄ and ► at the same time the manual switching can be activated
(keep both push buttons pressed  permanent switching)

Example:
Program: OFF
 Press push buttons: Manual ON
 Prolonged pressing of push buttons: Permanent ON
 Prolonged pressing of push buttons: Permanent OFF
By pressing both buttons again the manual / permanent switching is deleted again.

Manual / permanent switching priorities
o
Permanent switching is not deleted by other events.
o
Manual switching is deleted again by a program switching command.

horizontal top

Help lines for 24 hours at 0 and 24 hours

Help points at 6, 12 and 18 hours

48 segment bar graph displays, one line = 30 minutes
From 00:00:00 hours to 00:29:59 hours
From 00:30:00 hours to 00:59:59 hours
Page | 14