Static Ip Addressing - Nortel Contivity 1010 Manual

6
For PPP Authentication Settings, click on Configure. The PPP Local
Authentication screen appears.
7
Select either PAP or CHAP and enter the UID and password.
8
Click on OK.
9
To verify the state of PPPoE, you can look at the Operational State in the
System→LAN screen of the PPPoE. This indicates that PPPoE session is up.
To verify that IP/PPP/PPPoE is established, you can either check the event log
and search for PPPoE to see if IP is established or you can check the
forwarding table to see if a public default route is entered through the PPPoE
interface.
If you use Point to Point Protocol over Ethernet (PPPoE), you must use the
Web-based management utility for advanced configuration options on the PC to
enable it:
1
Open your Web browser and type http://192.168.1.2 and click on Manage
Switch and enter admin and setup as the username and password.
2
Go to the System→LAN screen, select PPPoE from the Select Protocol list
and click on Apply. The Add PPPoE Interface screen appears.
3
For Administrative State, click on Enable and for Interface Filter, select
permit all.
4
Click on OK.
5
Go to an external Web site to verify Internet access.

Static IP addressing

If you use static IP addressing, you must use the Web-based management utility
for advanced configuration options on the PC to enable it:
1 Open your Web browser and type http://192.168.1.2.
2 Enter admin and setup as the username and password.
3
Go to the System→LAN screen.
4 From the Select Protocol list, select IP and click on Apply. The Add IP
Address screen appears.
Chapter 2 Getting started 27
New Features for the Contivity 1010/1050/1100