Safety; Preamble; General Safety Instructions - Saeco Phedra Evo D.A. 5P2015 Operation And Maintenance

English
3

SAFETY

3.1

Preamble

In accordance with the
regulations, SAECO VENDING has prepared a technical
file relating to the PHEDRA EVO vending machine at its
premises, acknowledging the following standards in the
design stage:
- EN 55014
- EN 6100-3-2
- EN 61000-3-3
- EN 61000-4-2
- EN 61000-4-3
3.2

General Safety Instructions

It is forbidden to:
• tamper with or disable the safety systems installed on the
vending machine;
• carry out maintenance on the vending machine without
unplugging it first;
• install the vending machine on the outside. It is advisable to place
it in a dry place where the temperature does not drop below
2°C, in order to prevent any possible freezing.
• use the vending machine for purposes other than those indicated
in the sale contract and in this publication;
• electrically connect the appliance using multi-sockets or adapters;
• use jets of water for cleaning operations.
It is mandatory to:
• check conformity of the power supply;
• use original spare parts;
• carefully read the instructions contained in this manual and in the
attached documents;
• use personal protective equipment when performing installation,
testing and maintenance operations.
22
applicable standards and
- EN 61000-4-4
- EN 61000-4-5
- EN 61000-4-11
- EN 60335-2-75
- EN 60335-1
• Use a new gasket kit every time you disconnect and then
connect again the machine to the water supply.
Precautionary measures to prevent human errors:
• make the operator aware of safety issues;
• handle the vending machine, either packaged or unpackaged, in
safe conditions;
• deeply know the installation procedures, its correct operation
and its limits;
• dismantle the vending machine in safe conditions, in accordance
with the environmental protection and health and safety laws in
force.
To prevent
residues from coming into
contact with the beverages,
dispense about 0.5 l of
water for each dispensing
path before
starting the machine. The
dispensed beverages can
be drunk
performing this operation.
In case
malfunctioning, please refer
only to
personnel of the technical
service.
machining
definitely
only after
of failure or
the qualified