Saeco Phedra Evo D.A. 5P2015 Operation And Maintenance page 48

English
DISPLAY
1.3.4.
Filter reset
1.3.5.
Filter enabled
yes
1.4.
Temp. Boilers
1.4.1.
Boiler 1 temp.
1.4.1.1.
Min. Temperature
00
1.4.1.2.
Max. Temperature
000
1.4.2.
Boiler 2 temp.
1.4.2.1.
Temperature
00
1.5.
Energy save
...
1.5.1.
Stand-by timeout
1.5.2.
Eco timeout
1.5.3.
Delta temp. Eco
1.6.
Rinsing cycle
yes
1.6.1.
Automatic
48
Select YES to indicate a new filter has been installed
This operation returns "Remaining Qty" to the same value as "Filter Limit" and the date in
the "Last Filter Change" is changed to today's date.
Enables management of the "Remaining Qty" countdown.
Important
From the maintenance menu (button P2 on the CPU), you can access "Water Filter", "Last
Filter Change", "Remaining Qty" and "Filter Reset".
According to the model, the Phedra vending machine may be equipped with 1 or 2 boilers.
The following "BOILERS TABLE" matches the boilers with the vending machine models.
This menu option allows setting the operating temperature of boiler 1.
It allows you to set the temperature that the vending machine keeps for a few minutes after
a beverage has been brewed.
The set value is expressed in centigrade.
It allows you to assign the temperature to which the vending machine is brought after a
certain time from the last dispensing, so that the natural lowering of the temperature of the
hydraulic circuits can be compensated.
The set value is expressed in centigrade.
This menu option allows setting the operating temperature of boiler 2.
It allows you to set the temperature that the vending machine keeps for a few minutes after
a beverage has been brewed.
The set value is expressed in centigrade.
The "Stand-by" and "ECO" modes allow reducing the energy consumption of the machine.
It is possible to select one or both modes.
The "Stand-by" mode is activated after some minutes of inactivity which can be set by
means of this menu option. By setting it to zero the function is disabled.
When the "Stand-by" mode is activated the coffee and steam boilers are off and the display
shows the message "Stand by".
To exit the "Stand-by" mode, press any button or insert some credit.
When normal operation is restored, the boilers are turned on and the vending machine
starts the warm-up phase.
The "ECO" mode is activated after some minutes of inactivity which can be set by means of
this menu option. By setting it to zero the function is disabled.
In "ECO" mode, the target temperature of the boiler is reduced by a preset value (see the
following menu option).
The vending machine remains in its "Ready" status and no message is shown to the user.
To exit the "ECO" mode, press any button or insert some credit.
When "ECO" mode is deactivated, the target temperature for boiler 2 is restored and the
machine starts the warm-up phase.
Allows to set by how many °C the steam boiler temperature must be reduced during the
"ECO mode" phase.
It allows enabling of the automatic rinsing of the mixing bowls.
The automatic rinsing is performed as follows: the first rinsing takes place 10 minutes after
the "machine ready" status; if necessary, other rinses occur 7 hours after the last dispensing.
Description