Fujitsu PRIMERGY RX800 S2 Operating Manual page 76

Configuring the Server
Ê Use the Create Scalable Partition Settings page to define the scalable partition.
Perform this step to create a new partition. A page similar to the one in the
following illustration is displayed.
Ê In the Partition merge timeout minutes field, select the number of minutes
POST waits for the scalable nodes to merge resources. Allow at least 8
seconds for each GB of memory in the scalable partition. You can view
the merge status on the monitor attached to the primary node.
Ê In the On merge failure, attempt partial merge? field, select if POST should
attempt a partial merge if one error is detected during full merge. You can
view the merge status during POST on the monitor attached to the
primary node.
Ê In the Scalable Partition Number (ID) field, type a unique identifier for this
scalable partition.
The Primary Scalable Node field displays the primary node chassis
i
ID.
70
Preparation for Operation
U41621-J-Z156-1-76