Hot-plug Components
Ê Connect one end of the power cord for the new power supply into the
connector on the back of the power supply; route the power cord through the
cable-management arm and connect the other end of the power cord into a
properly grounded electrical outlet.
Ê Make sure that the AC power LED on the rear of the power supply and the
AC and DC power LEDs on the top of the power supply are lit, indicating that
the power supply is operating correctly.
Locking handle
(open)
Figure 25: Installing a hot-plug power supply
Ê Reinstall the cover and slide the server into the rack.
U41621-J-Z156-1-76
Hot-plug power supplies
Locking latch
Power supply 2 (PS2)
Power supply 1 (PS1)
AC
DC
AC power
LED (green)
DC power
LED (green)
111