Configuring Asdm Access For The Asa Services Module - Cisco ASA Series Cli Configuration Manual

Chapter 1 Getting Started
Command
Step 7
write memory
Example:
hostname(config)# write memory
Step 8
(Optional)
mode multiple
Example:
hostname(config)# mode multiple
Step 9
To launch ASDM, see the
section on page 1-14.
Examples
The following configuration converts the firewall mode to transparent mode, configures the Management
0/0 interface, and enables ASDM for a management host:
firewall transparent
interface management 0/0
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd enable management
http server enable
http 192.168.1.0 255.255.255.0 management

Configuring ASDM Access for the ASA Services Module

Because the ASASM does not have physical interfaces, it does not come pre-configured for ASDM
access; you must configure ASDM access using the CLI on the ASASM. To configure the ASASM for
ASDM access, perform the following steps.
Prerequisites
•
•
"Starting ASDM"
ip address 192.168.1.1 255.255.255.0
nameif management
security-level 100
no shutdown
Assign a VLAN interface to the ASASM according to the
ASA Services Module" section on page
Connect to the ASASM and access global configuration mode according to the
ASA Services Module Command-Line Interface" section on page
Configuring ASDM Access for the ASA Services Module
Purpose
Saves the configuration.
Sets the mode to multiple mode. When prompted, confirm that
you want to convert the existing configuration to be the admin
context. You are then prompted to reload the ASASM. See
Chapter 1, "Configuring Multiple Context Mode,"
information.
"Assigning VLANs to the
1-4.
Cisco ASA Series CLI Configuration Guide
for more
"Accessing the
1-2.
1-11