Configuring The Traffic Selectors For Wan Interfaces - Cisco ISA500 Series Administration Manual

Networking
Configuring the Quality of Service
STEP 3
STEP 4
NOTE
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
If needed, you can enter a brief description for each queue in the Queue
Description field.
Click Save to apply your settings.

Configuring the Traffic Selectors for WAN Interfaces

Traffic Selector (or Traffic Classification) is used to classify the traffic through WAN
interfaces to a given traffic class so that traffic in need of management can be
identified.
The security appliance allows you to create up to 256 traffic selectors.
Click Networking -> QoS -> WAN QoS -> Traffic Selector (Classification).
The Traffic Selector window opens. All existing traffic selectors are listed in the
table.
To add a new traffic selector, click Add.
Other options: To edit an entry, click Edit. To delete an entry, click Delete.
After you click Add or Edit, the QoS Class - Add/Edit window opens.
Enter the following information:
• Class Name: Enter a descriptive name for the traffic class.
• Source Address: Choose Any or choose an existing address or group
address (network) that the traffic comes from.
• Destination Address: Choose Any or choose an existing address or group
address (network) that the traffic goes to.
If the address objects you want are not in the list, choose Create a Group
Address to create a new group address object or choose Create a Single
Address to create a new address object. To maintain the address or group
address objects, go to the Networking -> Address Object Management
page. See Address Management, page
• Source Service: Choose Any or choose an existing service from the drop-
down list.
152.
4
144