Wall Mounting - Cisco ISA500 Series Administration Manual

Getting Started
Installation
WARNING
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliance Administration Guide
• Mechanical Loading: Be sure that the security appliance is level and stable
to avoid any hazardous conditions.
To place the security appliance on a desktop, install the supplied four rubber feet
on the bottom of the security appliance. Place the security appliance on a flat
surface.

Wall Mounting

There is no wall-mounting kit included with your security appliance. We
recommend that you use the following screws to install your security appliance to
the wall or the ceiling:
1
2
1 8mm/0.32 in
Insecure mounting might damage the device or cause injury. Cisco is not
responsible for damages incurred by improper wall-mounting.
To mount the security appliance to the wall:
Determine where you want to mount the security appliance. Verify that the surface
is smooth, flat, dry, and sturdy.
Insert two 18.6 mm (0.73 inch) screws, with anchors, into the wall 234 mm apart
(9.21 inches). Leave 3 to 4 mm (about 1/8 inch) of the head exposed.
Place the security appliance wall-mount slots over the screws. Slide the security
appliance down until the screws fit snugly into the wall-mount slots.
3
4
2 25mm/0.98 in 3 6.5mm/0.26in
1
4 18.6mm/0.73in
20