Cisco ISA500 Series Administration Manual page 120

Integrated security appliance
Hide thumbs Also See for ISA500 Series:
Table of Contents

Advertisement

Networking
Configuring the WAN Redundancy
NOTE
STEP 1
STEP 2
STEP 3
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
To configure the Loading Balancing, make sure that you configure both WAN ports
to Keep Live. If the WAN port is configured to time out after a specified period of
inactivity, then the Loading Balancing is not applicable.
Click Networking -> WAN Redundancy -> WAN Redundancy Operation
Configuration.
The WAN Redundancy Operation Configuration opens.
Use the Load Balancing mode if you want to use both ISP links simultaneously. The
two links will carry data for the protocols that are bound to them. Enter the
following information:
Equal Load Balancing (Round Robin): Re-orders the WAN interfaces for
Round Robin selection. The order is as follows: WAN1 and WAN2. The Round
Robin will then repeat back to WAN1 and continue the order. This is the
default setting.
Weighted Load Balancing: Distributes the bandwidth to two WAN ports by
the weighted percange or by the weighted link bandwidth. If you choose this
mode, choose one of the following options and finish the setting:
-
Weighted By Percentage: Allows you to set the percentage for each
WAN, such as 80% percentage bandwidth for WAN1 and lest 20%
percentage bandwidth for WAN2.
-
Weighted By Link Bandwidth: Allows you to set the rate limiting for each
WAN, such as 10 Mbps for WAN1 and 5 Mbps for WAN2.
If you choose Load Balancing as the WAN redundancy operation mode, you can
optionally enable the Policy-based Routing (PBR) settings to determine how the
traffic is balanced between the two ISP links. The PBR settings specify the internal
IP and/or service going through a specified WAN port to provide more flexbile and
granular traffic handling capabilities.
Policy Based Routing Enable: Click On to enable the PBR settings, or click
Off to disable it. To configure the PBR settings, click Configure PBR.
If you enable PBR, the PBR settings will be applied first and then the
NOTE
load balancing settings next.
4
114

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Isa550Isa570Isa570wIsa550w

Table of Contents