Cisco ISA500 Series Administration Manual page 141

Networking
Configuring the Routing
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
Click Networking -> Routing -> Policy Based Routing.
The Policy-based Routing window opens.
Click On to enable PBR, or click Off to disable it.
To add a new PBR rule, click Add.
Other options: To edit an entry, click Edit. To delete an entry, click Delete.
The Policy-based Routing - Add/Edit window opens.
Enter the following information;
• From VLAN: Choose the VLAN for the outbound traffic.
• Service: For service binding only, choose an existing service or choose
Create New Service to create a new service. For IP binding only, choose All
Traffic.
• Source IP: For service binding only, choose Any. For IP binding only, choose
an internal IP address that passes through the specific WAN port.
• Dest IP: For service binding only, choose Any. For IP binding only, choose an
IP address as the destination IP address of the outbound traffic. If the
address object is not in the list, choose Create New Address to create a
new address object. To main the address objects, go to the Networking ->
Address Object Management page. See
page 152.
• DCSP: Choose the DCSP remarking value to assign the traffic priority.
• Route to: Choose the WAN interface that the outbound traffic passes
through.
• Failover: Click On to enable WAN Failover, or click Off to disable it. When the
selected WAN interface for routing is down, enabling Failover will forward
the traffic to the backup WAN.
If one WAN connection is down (a connection failure is detected by
NOTE
ping the host or DNS server) and the PBR Failover is "Off", the traffic
will be dropped.
Click OK to save your settings.
Address Management,
4
135