IBM 6400i Setup Manual page 65

Left Ribbon Spool
Left Ribbon
Spool
Pedestal Models
Figure 46. Cabinet and Pedestal Models, Interior View of Ribbon Installation
9. Starting from the right ribbon spool, thread the ribbon around the right
ribbon guide, under the right tractor door, between the hammer bank
cover and ribbon mask, and along the ribbon path to the left ribbon guide.
10. Place the empty spool on the left hub.
11. Press the spool down until the hub latch snaps into place.
12. Turn the left spool by hand and check to ensure that the ribbon tracks
correctly in the ribbon path and around the ribbon guides.
NOTE: Printers with the "Clean Hands" ribbon automatically load the ribbon
13. Close the forms thickness lever.
when the first print job is sent.
Install The Ribbon
Setting Rear Paper Exit
Cabinet Models
Forms Thickness
Lever
Forms Thickness
Lever
65