Hex Transparent Control
This option allows you to enable (the default) or disable additional features
that are not available in standard IBM emulations. To access these features,
send lead-in character text commands in the data stream. You can also use
ASCII codes 80 hex through 9F hex as control codes if configured to do so.
Lead-In Characters
The Lead-In Character commands must have a start and end code. Set 1 is
the factory default. Three sets (each containing a start and end code) are
available:
•
Set 1: start code = <% (the default)
end code = >
•
Set 2: start code =
end code = $
•
Set 3: start code = _%
end code = _
•
User Defined
User Defined Codes
•
Start Code 2: 5F (the default)
•
Start Code 1: 5F
•
Stop code: 5B
The codes can be set to x'40' - x'FF' range
Alternate Set 80 - 9F
This selection determines if ASCII codes 80 hex through 9F hex will be used
as control codes or printed as standard printable characters.
•
Printable (the default). Prints the alternate set as standard characters
•
Control Code. Selects the alternate set to be used as printer control
codes.
Twinax Interface Menu
¬¬
121