IBM 6400i Setup Manual page 128

Chapter 4
Coax Interface Menu
Print Language
PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to the previous page for print language menus.
•
Standard Print Language (the default)
•
Alternate Print Language. Provides code pages compatible with 6408/
6412 Model CT0 printers. Use this option with the 3287 printer emulation.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and
OCR B are the only available values for this parameter. If a different print
quality value is desired, the print language must be changed first.
Print Character Table
PRINT CHARACTER TABLE prints out a table of the coax interface current
character set.
All coax character sets are shown in the 6400 Coax/Twinax Programmer's
Reference Manual.
Active Print Language
ACTIVE PRINT LANGUAGE specifies which print language set will be the
active set.
•
Standard Print Language (the default)
•
Alternate Print Language
PA1
PA1 is only valid when the printer is in the NOT READY state and the coax
System Network Architecture Character Set (SCS) data stream is active. This
function displays the "PA1 ENABLED" message when the Enter key is
pressed and sends a special operator request to the host when the printer is
made READY.
•
Disable (the default)
•
Enable
Refer to the 6400 Coax/Twinax Programmer's Reference Manual for more
information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED" appears on
128
the operator panel) or selecting the PA2 menu item will reset the
pending PA1 function.