Table of Contents
Advertisement
EQN2200
motion detection ceases.
Pre-Alarm Buffer: Image saved internally in the camera from the time immediately
preceding the trigger. Input the desired length of pre-trigger buffer time. It can be
set up to 120 seconds.
Post-Alarm Buffer: Image saved internally in the camera from the time
immediately after the trigger condition has ceased/been reset. Input the desired
length of post-trigger buffer time. It can be set up to 120 seconds.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
Re-trigger Filter Setting
Re-trigger Filter: Set a re-trigger filter time, if another event is triggered during
this time, this triggered event will be ignored.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
4.7.4 Time Mask
34
Advertisement
Table of Contents
