EverFocus EQN22 Series User Manual page 22

Sender Address: Input sender's e-mail address, so that receiver can recognize the
sender when an event message is sent out.
Send Test Mail: Press
address.
Set FTP
The settings relating to an FTP server to be used to receive alarm images can be
configured.
FTP Server: Enter the IP address or the host name of the FTP server.
FTP Port: Enter the port number for FTP server. Default is 21.
Recording Path: Assign the recording path.
User Name: Set FTP User name.
Password: Set FTP password.
PASV mode: Check to enable Passive mode (most sites normally require Passive
mode). If unable to establish a connection, uncheck "PASV" mode.
Test FTP Server: Press
server.
Press Apply to apply the setting changes or Reset to reset without saving the
change.
button to send a test e-mail to the designated
button to send a test file to the designated FTP
22
EQN2200