Cisco ASA Series Cli Configuration Manual page 80

New Features
Table 1-5 New Features for ASA Version 9.0(1)/ASDM Version 7.0(1) (continued)
Feature
OSPFv3
Cisco ASA Series CLI Configuration Guide
1-18
Description
OSPFv3 routing is supported for IPv6. Note the following additional
guidelines and limitations for OSPFv2 and OSPFv3:
Clustering
•
OSPFv2 and OSPFv3 support clustering.
•
When clustering is configured, OSPFv3 encryption is not supported. An
error message appears if you try to configure OSPFv3 encryption in a
clustering environment.
•
When using individual interfaces, make sure that you establish the master
and slave units as either OSPFv2 or OSPFv3 neighbors.
•
When using individual interfaces, OSPFv2 adjacencies can only be
established between two contexts on a shared interface on the master unit.
Configuring static neighbors is supported only on point-to-point links;
therefore, only one neighbor statement is allowed on an interface.
Other
•
OSPFv2 and OSPFv3 support multiple instances on an interface.
•
The ESP and AH protocol is supported for OSPFv3 authentication.
•
OSPFv3 supports Non-Payload Encryption.
We introduced or modified the following commands: ipv6 ospf cost, ipv6 ospf
database-filter all out, ipv6 ospf dead-interval, ipv6 ospf hello-interval,
ipv6 ospf mtu-ignore, ipv6 ospf neighbor, ipv6 ospf network, ipv6 ospf
priority, ipv6 ospf retransmit-interval, ipv6 ospf transmit-delay, ipv6
router ospf, ipv6 router ospf area, ipv6 router ospf default, ipv6 router
ospf default-information, ipv6 router ospf distance, ipv6 router ospf exit,
ipv6 router ospf ignore, ipv6 router ospf log-adjacency-changes, ipv6
router ospf no, ipv6 router ospf redistribute, ipv6 router ospf router-id,
ipv6 router ospf summary-prefix, ipv6 router ospf timers, area range, area
virtual-link, default, default-information originate, distance, ignore lsa
mospf, log-adjacency-changes, redistribute, router-id, summary-prefix,
timers lsa arrival, timers pacing flood, timers pacing lsa-group, timers
pacing retransmission, show ipv6 ospf, show ipv6 ospf border-routers,
show ipv6 ospf database-filter, show ipv6 ospf flood-list, show ipv6 ospf
interface, show ipv6 ospf neighbor, show ipv6 ospf request-list, show ipv6
ospf retransmission-list, show ipv6 ospf summary-prefix, show ipv6 ospf
virtual-links, show ospf, show run ipv6 router, clear ipv6 ospf, clear
configure ipv6 router, debug ospfv3.
We introduced the following screens:
Configuration > Device Setup > Routing > OSPFv3 > Setup
Configuration > Device Setup > Routing > OSPFv3 > Interface
Configuration > Device Setup > Routing > OSPFv3 > Redistribution
Configuration > Device Setup > Routing > OSPFv3 > Summary Prefix
Configuration > Device Setup > Routing > OSPFv3 > Virtual Link
Monitoring > Routing > OSPFv3 LSAs
Monitoring > Routing > OSPFv3 Neighbors
Chapter 1 Introduction to the Cisco ASA