Feature History For The Switch For Use With The Asa Services Module - Cisco ASA Series Cli Configuration Manual

Chapter 1 Configuring the Switch for Use with the ASA Services Module
The following is sample output from the show firewall vlan-group command:
Router# show firewall vlan-group
Group vlans
----- ------
50 55-57
51 70-85
52 100
The following is sample output from the show interface vlan command:
Router# show interface vlan 55
Vlan55 is up, line protocol is up
Hardware is EtherSVI, address is 0008.20de.45ca (bia 0008.20de.45ca)
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
ARP type:ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:08, output hang never
Last clearing of "show interface" counters never
Input queue:0/75/0/0 (size/max/drops/flushes); Total output drops:0
Queueing strategy:fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
L2 Switched:ucast:196 pkt, 13328 bytes - mcast:4 pkt, 256 bytes
L3 in Switched:ucast:0 pkt, 0 bytes - mcast:0 pkt, 0 bytes mcast
L3 out Switched:ucast:0 pkt, 0 bytes
Feature History for the Switch for Use with the
ASA Services Module
Table 1-1
Table 1-1 Feature History for the Switch for Use with the ASASM
Feature Name
ASA Services Module support on the Cisco
Catalyst 6500 switch
ASA Services Module support on the Cisco
7600 switch
reliability 255/255, txload 1/255, rxload 1/255
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
4 packets output, 256 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
lists each feature change and the platform release in which it was implemented.
Platform
Releases
8.5(1)
9.0(1)

Feature History for the Switch for Use with the ASA Services Module

Feature Information
The ASASM is a high-performance security services
module for the Catalyst 6500 series switch, which you
configure according to the procedures in this chapter.
We introduced or modified the following commands:
firewall transparent, mac address auto, firewall
autostate (IOS), interface vlan.
The Cisco 7600 series now supports the ASASM.
Cisco ASA Series ASDM Configuration Guide
1-13