Cisco ASA Series Cli Configuration Manual page 441

Chapter 1 Starting Interface Configuration (ASA 5510 and Higher)
Table 1-3 Feature History for Interfaces (continued)
Feature Name
Support for Pause Frames for Flow Control on
the ASA 5580 10-Gigabit Ethernet Interfaces
Support for Pause Frames for Flow Control on
1-Gigabit Ethernet Interfaces
EtherChannel support
Releases Feature Information
8.2(2) You can now enable pause (XOFF) frames for flow control.
This feature is also supported on the ASA 5585-X.
We introduced the following command: flowcontrol.
8.2(5)/8.4(2) You can now enable pause (XOFF) frames for flow control
for 1-Gigabit interfaces on all models.
We modified the following command: flowcontrol.
8.4(1) You can configure up to 48 802.3ad EtherChannels of eight
active interfaces each.
We introduced the following commands: channel-group,
lacp port-priority, interface port-channel, lacp
max-bundle, port-channel min-bundle, port-channel
load-balance, lacp system-priority, clear lacp counters,
show lacp, show port-channel.
Note
EtherChannel is not supported on the ASA 5505.
Feature History for ASA 5510 and Higher Interfaces
Cisco ASA Series CLI Configuration Guide
1-37