Cisco ASA Series Cli Configuration Manual page 376

Monitoring Active/Standby Failover
Monitoring Active/Standby Failover
Note
After a failover event you should either re-launch ASDM or switch to another device in the Devices pane
and then come back to the original ASA to continue monitoring the device. This action is necessary
because the monitoring connection does not become re-established when ASDM is disconnected from
and then reconnected to the device.
To monitor Active/Standby failover, enter one of the following commands:
Command
show failover
show monitor-interface
show running-config failover
For more information about the output of the monitoring commands, refer to the Cisco ASA 5500 Series
Command Reference.
Feature History for Active/Standby Failover
Table 1-2
Table 1-2 Feature History for Optional Active/Standby Failover Settings
Feature Name
This feature was introduced.
IPv6 support for failover added.
Cisco ASA Series CLI Configuration Guide
1-18
Purpose
Displays information about the failover state of the unit.
Displays information about the monitored interface.
Displays the failover commands in the running configuration.
lists the release history for this feature.
Releases
7.0
8.2(2)
Chapter 1
Feature Information
This feature was introduced.
We modified the following commands: failover interface
ip, show failover, ipv6 address, show monitor-interface.
Configuring Active/Standby Failover