Cisco ASA Series Cli Configuration Manual page 595

Chapter 1 Configuring Logging for Access Lists
Firewall Mode Guidelines
Supported only in routed and transparent firewall modes.
IPv6 Guidelines
Supports IPv6.
Additional Guidelines and Limitations
ACE logging generates syslog message 106023 for denied packets. A deny ACE must be present to log
denied packets.
Default Settings
Table 1-1
Table 1-1
Parameters
log
Configuring Access List Logging
This sections describes how to configure access list logging.
Note
For complete access list command syntax, see the
and the
lists the default settings for extended access list parameters.
Default Extended Access List Parameters
"Using Webtype Access Lists" section on page
Configuring Logging for Access Lists
Default
When the log keyword is specified, the default
level for syslog message 106100 is 6
(informational), and the default interval is 300
seconds.
"Configuring Extended ACLs" section on page 1-4
1-2.
Cisco ASA Series CLI Configuration Guide
1-3