Cisco ASA Series Cli Configuration Manual page 839

Chapter 1 Configuring Twice NAT
hostname(config)# object network myInsideNetwork
hostname(config-network-object)# subnet 10.1.2.0 255.255.255.0
Step 2
Add a network object for the Telnet/Web server:
hostname(config)# object network TelnetWebServer
hostname(config-network-object)# host 209.165.201.11
Step 3
Add a network object for the PAT address when using Telnet:
hostname(config)# object network PATaddress1
hostname(config-network-object)# host 209.165.202.129
Step 4
Add a service object for Telnet:
hostname(config)# object service TelnetObj
hostname(config-network-object)# service tcp destination eq telnet
Step 5
Configure the first twice NAT rule:
hostname(config)# nat (inside,outside) source dynamic myInsideNetwork PATaddress1
destination static TelnetWebServer TelnetWebServer service TelnetObj TelnetObj
Because you do not want to translate the destination address or port, you need to configure identity NAT
for them by specifying the same address for the real and mapped destination addresses, and the same
port for the real and mapped service.
By default, the NAT rule is added to the end of section 1 of the NAT table, See the
PAT (Hide)" section on page 1-11
the NAT rule.
Step 6
Add a network object for the PAT address when using HTTP:
hostname(config)# object network PATaddress2
hostname(config-network-object)# host 209.165.202.130
Step 7
Add a service object for HTTP:
hostname(config)# object service HTTPObj
hostname(config-network-object)# service tcp destination eq http
Step 8
Configure the second twice NAT rule:
hostname(config)# nat (inside,outside) source dynamic myInsideNetwork PATaddress2
destination static TelnetWebServer TelnetWebServer service HTTPObj HTTPObj
for more information about specifying the section and line number for
Cisco ASA Series CLI Configuration Guide
Configuration Examples for Twice NAT
"Configuring Dynamic
1-27