Getting Started - Cisco ASA Series Cli Configuration Manual

Getting Started

This chapter describes how to get started with your ASA. This chapter includes the following sections:
•
•
•
•
•
•
•
•
•
Accessing the Appliance Command-Line Interface
For initial configuration, access the CLI directly from the console port. Later, you can configure remote
access using Telnet or SSH according to
is already in multiple context mode, then accessing the console port places you in the system execution
space. See
context mode.
Detailed Steps
Step 1
Connect a PC to the console port using the provided console cable, and connect to the console using a
terminal emulator set for 9600 baud, 8 data bits, no parity, 1 stop bit, no flow control.
See the hardware guide for your ASA for more information about the console cable.
Step 2
Press the Enter key to see the following prompt:
hostname>
This prompt indicates that you are in user EXEC mode. Only basic commands are available from user
EXEC mode.
Step 3
To access privileged EXEC mode, enter the following command:
hostname> enable
Accessing the Appliance Command-Line Interface, page 1-1
Accessing the ASA Services Module Command-Line Interface, page 1-2
Configuring ASDM Access for Appliances, page 1-6
Configuring ASDM Access for the ASA Services Module, page 1-11
Starting ASDM, page 1-14
Factory Default Configurations, page 1-18
Working with the Configuration, page 1-23
Applying Configuration Changes to Connections, page 1-27
Reloading the ASA, page 1-28
Chapter 1, "Configuring Multiple Context Mode,"
C H A P T E R
Chapter 1, "Configuring Management Access."
for more information about multiple
Cisco ASA Series CLI Configuration Guide
1
If your system
1-1