Cisco ASA Series Cli Configuration Manual page 486

Completing Interface Configuration in Transparent Mode
For the ASA 5505 and the ASASM, you must configure interface parameters for the following interface
types:
•
Guidelines and Limitations
•
•
•
•
Prerequisites
•
•
•
Cisco ASA Series CLI Configuration Guide
1-10
VLAN interfaces
You can configure up to four interfaces per bridge group.
For the ASA 5550, for maximum throughput, be sure to balance your traffic over the two interface
slots; for example, assign the inside interface to slot 1 and the outside interface to slot 0.
For information about security levels, see the
If you are using failover, do not use this procedure to name interfaces that you are reserving for
failover and Stateful Failover communications. See the
section on page 1-7 or the
the failover and state links.
Set up your interfaces depending on your model:
–
ASA 5510 and higher—Chapter 1, "Starting Interface Configuration (ASA 5510 and Higher)."
–
ASA 5505—Chapter 1, "Starting Interface Configuration (ASA 5505)."
–
ASASM—Chapter 1, "Configuring the Switch for Use with the ASA Services Module."
In multiple context mode, you can only configure context interfaces that you already assigned to the
context in the system configuration according to the
page 1-15.
In multiple context mode, complete this procedure in the context execution space. To change from
the system to a context configuration, enter the changeto context name command.
Chapter 1 Completing Interface Configuration (Transparent Mode)
"Security Levels" section on page
"Configuring Active/Active Failover" section on page 1-9
"Configuring Active/Standby Failover"
"Configuring Multiple Contexts" section on
1-2.
to configure