Cisco ASA Series Cli Configuration Manual page 382

Information About Active/Active Failover
Table 1-2 Failover Behavior for Active/Active Failover (continued)
Failure Event
Failover link failed at startup
Stateful Failover link failed
Failover link failed during operation
Cisco ASA Series CLI Configuration Guide
1-6
Active Group
Policy Action
No failover Become active
No failover No action
No failover n/a
Chapter 1 Configuring Active/Active Failover
Standby
Group Action Notes
Become active If the failover link is down at
startup, both failover groups on
both units become active.
No action State information becomes out of
date, and sessions are terminated if
a failover occurs.
n/a Each unit marks the failover
interface as failed. You should
restore the failover link as soon as
possible because the unit cannot fail
over to the standby unit while the
failover link is down.