Cisco ASA Series Cli Configuration Manual page 240

Configuring Multiple Contexts
hostname(config-class)# limit-resource rate conns 1000
hostname(config-class)# limit-resource rate inspects 500
hostname(config-class)# limit-resource hosts 9000
hostname(config-class)# limit-resource asdm 5
hostname(config-class)# limit-resource ssh 5
hostname(config-class)# limit-resource rate syslogs 5000
hostname(config-class)# limit-resource telnet 5
hostname(config-class)# limit-resource xlates 36000
hostname(config-class)# limit-resource routes 5000
hostname(config-class)# limit-resource vpn other 10
hostname(config-class)# limit-resource vpn burst other 5
Configuring a Security Context
The security context definition in the system configuration identifies the context name, configuration file
URL, interfaces that a context can use, and other settings.
Prerequisites
•
•
•
•
Cisco ASA Series CLI Configuration Guide
1-20
Perform this procedure in the system execution space.
For the ASASM, assign VLANs to the ASASM on the switch according to
the Switch for Use with the ASA Services Module."
For the ASA 5500, configure physical interface parameters, VLAN subinterfaces, EtherChannels,
and redundant interfaces according to
(ASA 5510 and Higher)."
If you do not have an admin context (for example, if you clear the configuration) then you must first
specify the admin context name by entering the following command:
hostname(config)# admin-context name
Although this context does not exist yet in your configuration, you can subsequently enter the
context name command to continue the admin context configuration.
Chapter 1
Chapter 1, "Starting Interface Configuration
Configuring Multiple Context Mode
Chapter 1, "Configuring