Ericsson BusinessPhone 50 User Manual page 15

g
Automatic redial1
d X
or
u
g (
Automatic redial1
BusinessPhone – Executive Telephone
Activate
During the call:
Press to activate (pre-programmed)
The automatic redial lamp is rapidly flashing and is lit when the
request is stored and activated. Verification tone.
Replace the handset or press to finish the procedure
You are called back if the called number finishes the ongoing call or
the next time the extension finishes a new call. The display shows:
AUTO REDIAL CALL
ANDERSEN ANDREAS
directory
Lift the handset when you are called back
(You can also press the line or loudspeaker key to answer in
handsfree mode.)
Notes: It is not possible to do a new request on a key
holding an already activated request until the existing one is
cancelled.
When the automatic redial lamp is rapidly flashing, your
telephone is busy and you cannot receive or make new
calls.
The number of redial attempts and how long the function is
active is programmed by your system administrator.
If you have activated a diversion on your telephone, this
function is not available.
If tandem configuration is activated, the secondary
telephone cannot use this function. See section
configuration" on page
Cancel
Press the relevant programmable key to cancel the
automatic redial request (pre-programmed)
Note: Depending on system programming, the automatic
redial request could be cancelled automatically.
200
redial
69.
Outgoing Calls
prog
"Tandem
15