Display Panel - HP Spectre Folio Maintenance And Service Manual

Display panel

Description
13.3-in, UHD (3840×2160), BrightView, WLED, UWVA, 400 nits, eDP+PSR, wedge TouchScreen display
panel with narrow bezel
13.3-in, FHD (1920×1080), BrightView, WLED, UWVA, 400 nits, eDP 1.4+PSR2, ultraslim TouchScreen
display panel with narrow bezel
13.3-in, FHD (1920×1080), BrightView, WLED, UWVA, 300 nits, eDP+PSR, ultraslim TouchScreen display
panel with narrow bezel
Before disassembling the computer, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
Remove the display panel:
NOTE: When using the heating gun in the following steps to dissolve the adhesive that secures the display
assembly, the heating gun temperature should be set to 60°C and the heating duration per edge should be
approximately 90 seconds.
1. Use a heating gun to apply heat to the bottom (1), left (2) and right, and top edges (3) of the display panel
to dissolve the adhesive that secures the display assembly.
2. Attach suction cups to the front left corners of the display panel and the display back cover.
Spare part number
L38698-001
L38696-001
L38697-001
Component replacement procedures 25