HP Spectre Folio Maintenance And Service Manual page 72

a. Webcam (see
b. Leather cover (see
c. System board (see
Remove the heat sink:
1. Release the adhesive foil strips (1) that secure the processor heat sink to the system board.
2. Remove the four Phillips M2.0×2.9 screws (2) that secure the processor heat sink to the system board.
3. Remove the processor heat sink (3).
4. Remove the graphics subsystem heat sink (4).
To install the heat sinks:
1. Install the graphics subsystem heat sink (1) onto the system board.
NOTE:
sure the metal clips (2) on the system board fully engage the heat sinks.
2. Install the processor heat sink (3) onto the system board.
64 Chapter 5 Removal and replacement procedures
Webcam on page
Leather cover on page
System board on page
When installing the graphics subsystem and processor heat sinks onto the system board, make
36)
41)
61)