Table of Contents
Advertisement
Reverse this procedure to install the transfer board.
Webcam
Description
FHD, infrared webcam (includes bracket)
Before removing the webcam, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4.
Remove the display panel (see
Remove the webcam:
1.
Disconnect the left webcam cable (1) from the transfer board.
2.
Release the left webcam cable from the retention clips (2) built into the display back cover.
3.
Disconnect the right webcam cable (3) from the transfer board.
4.
Release the right webcam cable from the retention clip (4) built into the display back cover.
5.
Remove the three Phillips M2.5×2.3 broad head screws (5) that secure the webcam and support bracket to
the display back cover.
6.
Remove the webcam support bracket (6).
36
Chapter 5 Removal and replacement procedures
Display panel on page
25).
Spare part number
L38705-001
Hide quick links:
Advertisement
Table of Contents
