HP Spectre Folio Maintenance And Service Manual page 70

2. Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect the TouchPad
cable from the system board.
3. Remove the four Phillips M2.0×2.9 screws (1) that secure the system board and the left and right I/O
brackets to the keyboard.
4. Remove the Phillips M2.0×2.3 broad head screw (2) that secures the system board to the keyboard.
5. Remove the left (3) and right I/O brackets (4).
NOTE:
6. Lift the front edge of the system board (1) until it rests at an angle.
62 Chapter 5 Removal and replacement procedures
The I/O brackets are available using spare part number L38684-001.