Error Messages - Panduit PAT1M4.0 Operation Manual

© Panduit Corp. 2018
iv.
v.
vi.
vii.
viii.
ix.
9B: Error Messages
The operator is constantly informed of the PAT1M4.0/PAT1.5M4.0 System's status by the PDM4.0 Dispenser's
display. If the system fails due to operator error or dispenser malfunction, the operator is alerted that an error has
occurred by two (2) types of signals: an alarm signal (audible) and the dispenser display (visual). The alarm signal
volume can be adjusted by turning the faceplate of the buzzer. The alarm pattern can be adjusted at the display
within the settings menu. The buzzer is located on the back of the PDM4.0 Dispenser next to the power switch.
PA27647A01_05
OPERATION MANUAL
ENGLISH
Press the "Cutter" icon to change the current status of the Cutter. When the "Cutter"
is enabled it will cut the carrier strip every 7 cable ties and the icon displays a green
check mark. When the "Cutter" is disabled it will not cut the carrier strip, and one
continuous carrier strip will exit the dispenser. The icon displays a red check mark when
disabled. Pressing the "Back" will return to the previous menu level.
Press the "Convey" icon to set the internal regulatory pressure for cable tie choice. This
procedure is covered in System Power Up and Setup, on Page 16. . Pressing the "Back"
will return to the previous menu level.
MAINTENANCE > SET> CONVEY
PSI
CONVEY 47
TIE PRESSURE RANGE
1M 47 - 52
1.5M 37 - 42
Press the "Alarm" icon to set the cadence for audible alarming. There are 3 different
cadences to choose. The default setting is Single. Each setting has a continuous
previewed prior to selection. Navigating to the next option using previous and next. The
Buzzer can also be de-activated within this menu. Once the option is selected, press the
back icon to accept. Pressing the "Back" will return to the previous menu level.
Press the "Language" button to select the language at the next menu. Pressing this
button will bring up the following display: The menu can be displayed in the following
languages: English (US), Deutsch (German), Française (French), Italiana (Italian),
Español (Spanish), Czech (Èeský), Chinese (Mandarin) and Japanese. The current
language chosen is shown in the middle of the display. Pressing the "Back" will return
to the previous menu level.
The "Unload" icon reverses the rotary receiver in order to unload or clear jams. The
gearing of the dispenser will allow turning the rotary receiver by hand. It is recommended
to only use the "Load" and "Unload" functions to rotate the rotary receiver. The rotary
receiver must not be pried. Pressing the "Back" will return to the previous menu level.
The "Collector" icon toggles the automatic tip collector counter off. The user will not
need to acknowledge the tip collector full after 300 successful cycles. This option is best
used in automated applications.
Page: 28 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
BAR
3.24
3.2 - 3.6
2.6 - 2.9
BACK
10
12-2018