System Power Up And Setup - Panduit PAT1M4.0 Operation Manual

© Panduit Corp. 2018
7D: System Power Up and Setup
1. Plug the supplied electric cord into the receptacle on the back of the dispenser (See Fig. 11 below). Plug the
other end into a grounded electrical outlet that matches the dispenser power requirements (Refer to the
Electrical Specifications section on Page 12). Set the power switch on the back of the dispenser (See Fig. 11
below) to the "on" position.
IMPORTANT: Only turn the power to the unit "on" or "off" using the power switch on the back of the
dispenser. Using any other method to turn the unit "on" or "off" may damage the unit.
Fig. 11
The following power up display will appear for 5 seconds:
Followed by the Load Ties Menu
PA27647A01_05
OPERATION MANUAL
ENGLISH
POWER UP
Automatic Cable Tie System
Page: 16 of 64
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
2
PAT
12-2018