Telnet Tips - Extron electronics FOX Matrix 320x User Manual

Telnet Tips

It is not the intention of this guide to detail all of the operations and functionality of Telnet;
however, some basic level of understanding is necessary for operating the FOX matrix
switcher via Telnet.
Open
Connect to the FOX matrix switcher using the Open command. Once you are connected to
the switcher, you can enter the SIS commands the same as you would if you were using the
RS-232 or RS-422 link.
Connect to the FOX matrix switcher as follows:
At the
1.
If the switcher is not password protected, no further prompts are displayed until
you break or disconnect the connection to the matrix switcher.
If the switcher is password protected, Telnet displays the password prompt.
2. If necessary, at the password prompt, type the appropriate password and then press
<Enter>.
Connection to the switcher via the Ethernet can be password protected. There are
two levels of password protection: administrator and user. A person logged on as an
administrator has full access to all matrix switcher switching capabilities and editing
functions. Users can create ties, set mutes, and view all settings with the exception of
passwords. By default, the FOX matrix switcher is shipped with both passwords set to
{
carriage return
Once you are logged in, the switcher returns either
. No further prompts are displayed until you break or disconnect the connection to
User
the FOX matrix switcher.
Escape character and Esc key
When Telnet is first started, the utility advises that the Escape character is 'Ctrl
SIS commands include the keyboard
between the Escape character and the Escape key.
The Telnet Escape character is a key combination, the
simultaneously, which returns you to the
FOX matrix switcher intact.
The Escape key is the
Local echo
Once connected to the FOX matrix switcher, by default, Telnet does not display your
keystrokes on the screen. SIS commands are typed in blindly and only the SIS responses
are displayed on the screen. To command Telnet to show keystrokes, at the
prompt, type
the switcher.
With local echo turned on, keystrokes and the responses of the switcher are displayed
on the same line. For example:
I
n1 Out1 All
With local echo turned on, all keystrokes are displayed, even those that should be masked,
such as the password entry. For example, when entering a password with local echo turned
on, you see a display such as
is the masked response.
*****
prompt, type
Telnet open {IP address}
}.
<
Esc key on the computer keyboard.
< >
and then press <Enter> before you open the connection to
set local_echo
1*1!In1 Out1 All
is the response.
a*d*m*i*n*
FOX Matrix 320x and FOX Matrix 14400 • Ethernet Connection
and then press <Enter>.
Login Administrator
Esc key. Consequently, some confusion may exist
>
Ctrl key and the
< >
prompt while leaving the connection to the
Telnet
, where is the SIS command and
1*1!
, where is the keyed in password and
admin
or
Login
]'. Many
+
] key pressed
< >
Telnet
86