Remote Port - Extron electronics FOX Matrix 320x User Manual

Remote Port

C Remote RS232/RS422 port (see
Connect a host device, such as a computer or touchpanel control, to the switcher via
this 9-pin D connector for serial RS-232 or RS-422 control (see figure 9).
9
6
Figure 9.
See Programming
(serial commands to control the switcher via this connector) and
beginning on page 36, for details on how to install and use the control software.
NOTE: The switcher can support either the RS-232 or the RS-422 serial
communication protocol, and can operate at 9600, 19200, 38400, or 115200
baud rates.
See the
Commands
If desired, connect an MKP 2000 or MKP 3000 remote control panel to the Remote
RS232/RS422 connector (see the MKP 2000 Remote Control Panel User Guide or the
MKP 3000 User Guide for details).
figure 3
Pin RS-232 Function RS-422
1 — Not used
2 Tx Transmit data
3 Rx Receive data
5
4 — Not used
5 Gnd Signal ground
1
6 — Not used
7 — Not used
8 — Not used
9 — Not used
Remote RS232/RS422 Connector
Guide, beginning on page 20, for definitions of the SIS commands
Command and Response Table for IP- and SNMP-Specific SIS
on page 33 to configure this port under SIS control.
FOX Matrix 320x and FOX Matrix 14400 • Installation
figure 4
on page 8 and
Function
— Not used
Tx– Transmit data (–)
Rx– Receive data (–)
— Not used
Gnd Signal ground
— Not used
Rx+ Receive data (+)
Tx+ Transmit data (+)
— Not used
Matrix
on page 9) —
Software,
13