Screen Assembly Mounts - FireplaceXtrordinair ProBuilder 72 Linear MV Installation Manual

Screen Assembly Mounts

The screen assembly mounts (located on outer front edges of the fireplace) are adjustable to allow the screen
assembly to be positioned 1/2" to 1-/12" from the front of the fireplace. This allows facing to tuck under the screen
assembly. Each mount is held in place by (3) Philips head screws. Before mounting the screen assembly, adjust
the mounts so that the front edge is flush with the finish material surrounding the fireplace. To adjust the mounts,
loosen the screws, slide the mounts to the desired position, then tighten the screws.
Screen assembly mount
© Travis Industries
Installation
(for qualified installers only)
Phillips
Screwdriver
may be slid forward to
accommodate facing.
Thin Facing (1/2" 13mm) - Top View
Fireplace
Screen Assembly
Mount
Thick Facing (1" 26mm) - Top View
Fireplace
Screen Assembly
Mount
1/2/19 - 1458
Position edge of mount
flush with finish material
Framing
Drywall
Max. 1/2" (13mm) Overlap
Framing
Drywall
Max. 1/2" (13mm) Overlap
PB 72 MV/GSB2 Install
39