FireplaceXtrordinair ProBuilder 72 Linear MV Installation Manual page 17

4 Remove the (4) screws from each of the (2) header shields (keep the screws for reinstallation). Turn
each of the shields over endwise and secure them back into place using the screws you just removed.
The bent edge of the shields should be facing upward and toward the back of the fireplace (see
illustration below).
5 The (2) header standoffs are screwed down flat to front edge of the top of the shields. On each standoff,
remove the screw that is closest to the outside edge of the fireplace (keep screw for reinstallation). Bend
the legs at the perforations as shown below and attach the foot of the standoff to the top of the fireplace
using the screw removed earlier in this step.
© Travis Industries
Installation
(for qualified installers only)
Attach the header shield to the
header standoff (both sides).
Bend the vertical standoff as
shown to the right (both sides).
1/2/19 - 1458
NOTE: Use the
forward hole for
standard position.
PB 72 MV/GSB2 Install
17