Pilot Assembly - FireplaceXtrordinair 36DV-AR Owner's Manual

O
PTIONAL
P 40
AGE
4 Remove the
pilot
assembly
with a 1/4"
nutdriver.
Use a 7/16"
open end
wrench to
unscrew the
pilot tube
compression
nut. Move
the pilot tube
down and
away from
the pilot
assembly.
5 Remove the pilot
orifice. It may be
resting on the pilot
tube or lodged
inside the pilot
assembly (tap the
assembly from
above until it falls
out). Place the
propane pilot orifice
onto the pilot tube
(the LP orifice is
.016" diameter - it
has "16" stamped on
it). Insert the pilot
tube (with orifice)
into the pilot tube
port and tighten the
compression nut
until tight. NOTE:
Leak test this
connection after
the heater is
installed and gas is
connected.
E (C
QUIPMENT
Pilot
Assembly
Pilot Tube Port
on Pilot Assembly
Pilot Orifice
Compression
Sleeve
Compression
Nut
)
ONTINUED
Pilot Assembly Gasket
Compression
Nut
Pilot Tube
Do not kink or
excessively bend this tube
- this may lead to leaks.
Pilot Tube
LP Pilot
NG Pilot
Orifice
Orifice
L
1 6 2 1
P N
Make sure the pilot orifice fits
over the compression sleeve.
WARNING:
The pilot tube connections are
a common location for gas
leaks. Take special care on
these gas connections and
leak test at both connections
after installing.