Volvo Penta D1-13 Workshop Manual page 84

21-5 Timing Gears and Shaft
2
3
P0008050
D1-20
P0007999
82
7
8
1
9
1
Place a new O-ring (1) in the groove in the raw
water pump.
Install the rear end piece (2) with a new gasket
and its four bolts (3).
NOTICE! The longest bolts must be placed on the
outside (D1-13, D1-20).
Install the raw water pump and bolt it secure.
Install the belt pulley key on the crankshaft.
Install the pulley and tighten it to the specified
torque with the center nut; refer to Tightening tor-
ques page 9.
Put the valve lifters in place as marked.
IMPORTANT!
All valve lifters must be put back in their previous
places. Note that on D1-20 engines, valve lifter no.
2 for cylinder 1 has a chamfer (1). Note that on
D2-40 engines, both valve lifters for cylinder 1
have a chamfer.
47701798 05-2013 © AB VOLVO PENTA