Volvo Penta D1-13 Workshop Manual page 60

21-1 Cylinder Head
14
18
15
16
11
12
P0008073
D1-30-A/B/F
20
P0008074
58
13
17
10
19
21
9 Install the oil supply pipe (10) between the block
and the rocker arm mechanism, together with the
oil pressure monitor (11). Install the oil pressure
relief valve (12). For tightening torques, refer to
Tightening torques page 9. Crank the crankshaft
a couple of revolutions.
10 Adjust the valve clearance; refer to Valves,
Adjustment page 70.
11 Install the valve cover (13). Check that the small
ventilation hole in the crankcase ventilation cover
(14) is open.
12 Install the copper gaskets for the injectors. Install
the injectors (15). For tightening torques, refer to
Tightening torques page 9.
13 Install the hollow screw (16) on the injection pump
and the banjo nipple with new copper washers.
14 Install new copper gaskets and install the return
fuel line (17). Tighten the nuts and connect the
return line.
15 Install the delivery pipes (18). For tightening tor-
ques, refer to Tightening torques page 9.
16 Install the coolant pump (19) with spacer (D1-13-
A/B/F) and a new gasket.
17 Clean the rear crankshaft seal seat in the engine
block and the mating surface on the inner fly-
wheel housing. Install the rear crankshaft seal
(20).
18 Apply an even, thin sealant layer (VP no. 840 879)
around the crankshaft seal and the camshaft
cover (21).
47701798 05-2013 © AB VOLVO PENTA