Volvo Penta D1-13 Workshop Manual page 18

03-2 Specifications, Engine
Cylinder block flatness
Service limit
Cylinder head
Warping, cylinder head
Maximum service limit
Maximum limit for regrinding cylinder head
Selecting cylinder head gasket:
Piston height above cylinder block upper edge
Select gasket thickness
Piston height above cylinder block upper edge
Select gasket thickness
Rocker arm shaft
Rocker arm shaft diameter:
D1-13-A/B/F, D1-20-A/B/F
Service limit
D1-30-A/B/F, D2-40-A/B/F
Service limit
Rocker arm play on rocker arm shaft:
D1-13-A/B/F, D1-20-A/B/F, minimum permissible play
D1-30-A/B/F, D2-40-A/B/F, minimum permissible play
Maximum permissible play, all engines
Crankshaft
Thrust bearings
Standard thickness
Service limit
NOTICE! The thrust bearings are pressed into the main bearing retainer.
Crankshaft end float
Service limit
Crankshaft deflection
Service limit
Front crankshaft bushing, diameter, journal
Standard, D1-13-A/B/F and D1-20-A/B/F
Service limit
Standard, D1-30-A/B/F and D2-40-A/B/F
Service limit
NOTICE! No undersize journal bushings are available.
16
Less than 0.05 mm (0.002")
0.12 mm (0.005")
0.00–0.05 mm (0.000–0.002")
0.12 mm (0.005")
0.15 mm (0.006")
0.55–0.64 mm (0.0217–0.0252")
1.2 mm (0.047")
0.65–0.75 mm (0.0256–0.0295")
1.3 mm (0.051")
9.950–9.968 mm (0.3917–0.3924")
9.87 mm (0.3886")
11.65–11.67 mm (0.4587–0.4595")
11.57 mm (0.4555")
0.032–0.065 mm (0.00126–0.00260")
0.032–0.068 mm (0.00126–0.00268")
0.2 mm (0.008")
21.85–21.95 mm (0.8602–0.8642")
21.60 mm (0.8504")
0.10–0.30 mm (0.0040–0.0118")
0.50 mm (0.0197")
0.30 mm (0.0011") or less
0.06 mm (0.0023")
42.964–42.975 mm (1.69150–1.69193")
42.90 mm (1.6890")
47.965–47.975 mm (1.88830"–1.88880")
47.90 mm (1.8858")
47701798 05-2013 © AB VOLVO PENTA