Volvo Penta D1-13 Workshop Manual page 61

38
29
28
26
25
24
23
40 22
P0008075
35
36
31
34
P0008076
47701798 05-2013 © AB VOLVO PENTA
27 39
30
37
32
33
19 Install the inner flywheel housing (22). Install the
flywheel (23) according to the marks made ear-
lier. For tightening torques, refer to Tightening
torques page 9. Then install the vibration damper
(24) and the flywheel housing (25). Install the
engine rpm sensor (26) on the flywheel housing.
20 Install the oil dipstick tube (27).
21 Install the fuel filter bracket (28) with attachment
fitting, and the feed pump (29). For tightening tor-
ques, refer to Tightening torques page 9.
Connect the fuel hoses and tighten the hose
clamps.
22 Install the heat exchanger / exhaust manifold (30)
and raw water pump (31).
23 Install the starter motor (32) and alternator (33),
together with the front engine mounting (34).
24 Install the expansion tank and attachment fitting
(35).
25 Connect all coolant hoses (36). Tighten all hose
clamps and brackets.
26 Install the electronics box (37) with cable har-
ness; connect the connectors and other electrical
connections. Clamp the cable harness as previ-
ously noted.
27 Install the induction silencer (38).
28 Remove the engine fixture and install the engine
mounting (39).
29 Install a new oil filter (40). Add oil and coolant;
refer to Group 22: Lubrication System page 20.
30 Install the engine in the boat. Connect the remain-
ing connections and controls to the engine. Open
the fuel taps and the sea cock. Start the engine
and check that no leakage occurs.
21-1 Cylinder Head
59