Table of Contents
Advertisement
Using a network computer
Using the File Transfer Protocol (FTP)
Make sure that the printer is in ready state before flashing the printer.
1
Turn on the printer.
2
Obtain the IP address:
•
From the home screen
•
From the TCP/IP section of the Network/Ports menu
3
From the command prompt of a network computer, open an FTP session to the printer IP address.
4
Use a PUT command to place the firmware file on the printer.
The printer performs a POR sequence and terminates the FTP session.
5
Repeat steps 2 through 4 for the other files.
Using the Embedded Web Server
Make sure that the printer is in ready state before flashing the printer.
1
Open a Web browser, and then type the printer IP address.
2
From the home page, navigate to Configuration > Update Firmware.
3
Select the file to use.
The printer performs a POR sequence and terminates the FTP session.
4
Repeat steps 2 through 4 for the other files.
Ribbon cable connectors
Zero Insertion Force (ZIF) connectors
Zero Insertion Force (ZIF) connectors are used on the boards and cards used in this printer. Before inserting or
removing a cable from these connectors, read this entire section. Great care must be taken to avoid damaging
the connector or cable when inserting or removing the cable.
Warning—Potential Damage: Do not insert the cable so that the contacts are facing the locking actuator.
The contacts always face away from the actuator.
Warning—Potential Damage: Do not insert the cable diagonally into the ZIF socket. This can cause damage
to the contacts on the cable.
Warning—Potential Damage: Avoid using a fingernail, or sharp object to open the locking mechanism. This
could damage the cable.
Warning—Potential Damage: Avoid pressing against the cable when opening the locking mechanism. This
can also damage the cable.
These are the types of ZIF connectors used in this printer:
•
Horizontal top contact connector
•
Horizontal bottom contact connector
Parts removal
178
4514-2xx
Advertisement
Table of Contents
