Ribbon Cable Connectors; Zero Insertion Force (Zif) Connectors - Lexmark MS510 Service Manual

Importing eSF solutions and settings file
After replacing the controller board, import back to the printer the eSF solutions and settings that were exported.
1
POR the printer into Invalid engine mode. See
2
Open a Web browser, and then type the printer IP address.
Note: If the Web page cannot be accessed or an error occurs when starting the printer into Invalid engine mode,
then data backup is not an option. Inform the customer that the data cannot be saved.
3
Navigate to Settings > Solutions > Embedded Solutions.
4
From the Embedded Solutions page, select the applications that you want to import.
5
Click Import.

Ribbon cable connectors

Zero Insertion Force (ZIF) connectors

Zero Insertion Force (ZIF) connectors are used on the boards and cards used in this printer. Before inserting or removing
a cable from these connectors, read this entire section. Great care must be taken to avoid damaging the connector or
cable when inserting or removing the cable.
Warning—Potential Damage: Do not insert the cable so that the contacts are facing the locking actuator. The
contacts always face away from the actuator.
Warning—Potential Damage: Do not insert the cable diagonally into the ZIF socket. This can cause damage to the
contacts on the cable.
Warning—Potential Damage: Avoid using a fingernail, or sharp object to open the locking mechanism. This could
damage the cable.
Warning—Potential Damage: Avoid pressing against the cable when opening the locking mechanism. This can also
damage the cable.
These are the types of ZIF connectors used in this printer:
• Horizontal top contact connector
•
Horizontal bottom contact connector
•
Vertical mount contact connector
• Horizontal sliding connector
"Entering Invalid engine mode" on page
Repair information
164
4514-6xx
154.