Profibus Flexible Cable - Siemens SIMATIC NET PROFIBUS Owner's Manual

4.1.5

PROFIBUS Flexible Cable

Filler
(polyester yarn)
Cores, stranded copper
Cellular PE insulation
Figure 4-5 Structure of the Flexible Cable (Robot Cable)
PROFIBUS flexible cable 6XV1 830-0FH10
The flexible cable 6XV1 830-0FH10 complies with the specification EN 50170,
Cable Type A, with stranded copper cores (approximately 24 gauge - 19/36) apart
from the higher loop resistance.
This difference means a reduced segment length; refer to the table in Chapter 3
"Notes on Configuration".
In contrast to the standard LAN cable, the cores of the flexible cable are of
stranded copper. In conjunction with the special combination of braid shield, foil
shield, fleece layer and the sheath material of polyurethane, the cable has a
torsional strength of 180
The cable has been tested to a minimum of 5 million torsional movements on one
meter cable length ( 180
If screw terminals are used, the stranded cores must be fitted with wire-end
ferrules (0.25 mm
The bus connector 6ES7 972-0BA30-0XA0 cannot be connected.
The cable is not suitable for use of the FastConnect (FC) stripping tool.
PROFIBUS Networks SIMATIC NET
6GK1970-5CA20-0AA1 Release 2 05/2000
Passive Components for RS-485 Networks
o
while retaining highly constant electrical characteristics.
o
).
2
complying with DIN 46228).
PUR outer sheath
Plastic foil
Copper braid shield
Conductive fleece
layer
4-11