General Parameters - Theben KNX Series Handbook

4.5 General parameters

4.5.1 General
Designation
Reduce brightness
of the LEDs
Object type
Value for reduced
brightness
Function of the
external inputs
I3+I4

The external inputs I3 and I4 can be used as analogue inputs for temperature
measurement via remote sensor.
RAMSES 718 P / RAMSES 718 S
Values
never
always
only in night mode
in the dark
via bus
via switch object
via percentage value
0-100%
Std. = 30%
Binary input
Temperature sensor input
The application programmes RAMSES 718 P/S
Description
The LEDS should:
Shine every time at maximum brightness.
Always shine at the specified brightness
Shine at the specified brightness if the
RTC is set to night mode.
Shine at the specified brightness when it
is dark in the room.
Be able to be reduced or dimmed via bus
telegrams.
Brightness reducible via switch telegram.
The brightness of the LEDs can be set as
desired via dimming telegrams.
LED brightness for the setting always only
in night mode, or via switch object.
I3 and I4 are normal binary inputs, as I1
and I2.
I3 and I4 or used for temperature
measurement, as well as for the internal
RTC and for other bus sharing units. For
this purpose, always one remote sensor is
connected.
34